Mylex PCI to Ultra 160 SCSI RAID Controller AcceleRAID 170 Guida di Installazione Scaricare il pdf (Pagina 30)

Installation Process

2-10 AcceleRAID 170 Installation Guide

Preparing the SCSI Drives

To prepare the drives for installation, follow these steps:

1. Remove any terminators attached to the drive or set any drive

termination jumpers to the disabled position.

2. Set the SCSI IDs on the drives.

3. Enable term power on the drives.

Refer to the drive manual for specific information about drive configuration

settings.

Installing Cables and Setting Termination

Please refer to Table 2-3 on page 2-15 for SCSI Formats and Bus Length

requirements.

4. Connect the SCSI cable from the internal disk drive to the SCSI

connector on the AcceleRAID 170 controller as shown in

Figure 2-8. (The controller is already connected to the system board.)

Figure 2-8. Connecting Disk Drives to the AcceleRAID 170

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 81 82

Nessun commento

Mylex PCI to Ultra 160 SCSI RAID Controller AcceleRAID 170 Guida di Installazione Pagina 30